Flex TPO Extension Legs User Manual download pdf

_____________________________________________________________________________________________________

Flex Membrane International Corp. 2670 Leiscz’s Bridge Road, Suite 400, Leesport, PA 19533

Tel: (610) 916-9500 Fax: (610) 916-9501 www.FlexRoofingSystems.com

Page 1

Product Data Sheet

FLEX TPO EXTENSION LEGS

PRODUCT DESCRIPTION

Flex TPO Extension Legs are designed for use with the Flex TPO Molded Sealant Pocket to extend the

sealant pocket by increments of ten inches. Fabricated from 45 mil thick TPO reinforced membrane and

TPO coated metal, the Flex Extension Legs can be used full length, cut to size for customized lengths or

welded to each other for extra long applications. They are packaged 10 legs per carton and available in

white.

PHYSICAL PROPERTIES

Size: 14” overall length, 10” installed length

Packaging: 10 per carton

Weight (per box): 6 lbs.

Material: Reinforced TPO membrane and coated metal

Color: White

INSTALLATION

1. Clean the inside of the Flex TPO Extension Legs and Flex TPO Molded Pockets as well as the

areas where the pocket overlaps, the underside of the pocket flange and the deck membrane with

Flex Weathered Membrane Cleaner. Use a Primer Pad with the cleaner if the membrane has been

exposed for an extended period of time.

2. Place the Flex TPO Molded Pocket and the Flex TPO Extension Legs around the penetration(s),

overlapping the two sections of the pocket with the extension legs. The extension legs must be

positioned as follows: the two-inch TPO overlap tab is placed on the topside of the molded pocket

and the opposite end (with no welding tab) is placed on the underside of the opposing molded

pocket.

3. Cut a piece of cardboard (approximately 4” x 4”) and place it under the overlap area to be welded.

The cardboard prevents the pocket and extension leg from fusing to the deck membrane when first

welding overlaps.

4. Using a hand welder, weld the angle change in the overlap areas at each end of the extension leg.

Using the end of a seam probe assists in this process. (The hand-welder temperature setting

should be between 5 and 6).

5. Hand-weld the remainder of the horizontal overlaps.

1 2

Product Data Sheet 1

Summary of Contents

Page 1 - Product Data Sheet

_____________________________________________________________________________________________________ Flex Membrane International Corp. 2670 Leiscz’s

Page 2

_____________________________________________________________________________________________________ Flex Membrane International Corp. 2670 Leiscz’s

Comments to this Manuals

No comments

Flex TPO Extension Legs User Manual

Browse online or download User Manual for Hardware Flex TPO Extension Legs. Flex TPO Extension Legs User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Hardware Flex TPO Extension Legs